Conveyor Belt Brush

Conveyor Belt Brush

Conveyor Belt Brush

For adjusting the pressure it is sufficient to operate upon both side tension rods: this operation is important, because it allows to reduce the strip’s wear-out and without affecting the cleaning operation of the conveyor belt.   The strip brushes replacement is very simple and does not require disassembling the metal body. It is sufficient to screw-out the wedges held by a set of screws, then pull the brushes out either side ways or radial ways, depending on how you can grab them best.        The rotation speed of the brush must be carefully selected in accordance with both the conveyor belt speed and the type of the material to be removed.   The rotation direction of the Brush and of the conveyor belt must be opposite.

Description

Conveyor Belt Brush

Brushing Unit for Conveyor Belts

 

The Brushing Units must be mounted in parallel with the conveyor belt (pls. see picture), exactly where the belt leaves the head-drum or immediately behind the vertical of the drum axle           making sure that the supports are aligned.           If the Brushing Units are mounted in any other positions, an idle roll must be placed against the other side of the belt, so that the brush operates where the belt is tight.   The power supply must be provided so as to start and stop both brush and conveyor belt at the same time.   It is recommended to bear in mind that the wires tips are constantly under working stress, therefore an excessive pressure would reduce the brushing effectiveness of the whole unit and accelerate the brush wear-out. The picture shows the correct bending of the filaments and the correct pressure between the brush and the belt.

Reviews

There are no reviews yet.


Be the first to review “Conveyor Belt Brush”

You've just added this product to the cart: